Wash your hands in hot water for about a minute.
This will increase blood circulation in your fingers.
Dry your hands.
Doing a blood test without stimulating blood circulation might prove difficult, so please do not skip this step.

Rotate the protective cover on the blood lancet to remove it.

Disinfect your “test finger” with the supplied disinfectant paper.
Wait a few seconds until the finger is completely dry.

Place your hand on a flat surface.
Put the lancet diagonally toward the test finger and press down the button.
Make sure the lancet is pressed against the finger the whole time.

We recommend that you stand up at this stage to let the blood in your arm flow downward.
Help the blood drops come out by massaging the finger toward the needle stick.

Without squeezing the capillary dropper bulb, put it in contact with the blood.
The blood migrates into the capillary dropper.

Hold the dropper vertically and transfer 1 drop of blood in each ”S” well of test casette, by squeezing the the bulp.
Wait for 1 minute

Add 4 drop of buffer into Buffer well of test casette.
Read Result after 1 minute.
Do not interpret the result after 30 minutes.

Note: If a small amount of red blood cells is observed in the ”S” well at reading time, please add 1-2 drops of buffer to ”Buffer” well and read the result immediately.

Interpretation of results